Advanced Service And Parts LLC [home link]
0
1.800.630.1230

TG410 TOUGH Series Digital Genset Control, DynaGen

$499.00  $399.00
Save: 20% off

1511
  • Part #: TG410
  • 23 Units in Stock

    Tough Series - For engines or generators

    The TOUGH series controllers are designed to provide complete control, protection and engine instrumentation for both standard and electronic CAN Bus engines as well as metering for generator applications.

    All modules in this series are easily configured as either engine controllers or as generator controllers using either the front panel buttons or our PC configurator software.

    TOUGH series controllers are ideally suited for severe duty applications where reliability is critical such as mobile or stationary engine equipment and generators.

    The TG410 is the most advanced option in the TOUGH Series, providing displays of Oil Pressure, Engine Temperature, Fuel Level, Oil Level, Engine Hours, RPM and Battery Voltage as well as J1939 Diagnostic Trouble Codes and a 150 Event Log.  Two customer-defined sensor parameters for temperature, pressure, voltage or levels can also be configured.  For generator applications, the TG410 provides a display of 3-Phase AC voltage, 3-Phase AC current, and frequency.  A Modbus communications port is standard on the TG410 model, allowing connection of a remote annunciator or an Internet gateway for remote management.  For applications requiring Auto Mains Failure operation, the TG350AMF model is recommended.

    Download Tech Sheet

    Download User Manual Here

    Accessories for the TG410:

    Are you using the relay pack? If so, order DWG1475 and RP-100

    If you do NOT need the relay pack, you'll need harness DWG1476

    For displaying AC volts or using the generator output to sense speed, use harness DWG1479

    If the engine is electronic (CANBUS/J1939 capable), or you're using a magnetic pickup for speed sensing or you're needing Modbus capabilities (such as a RA400 or Netbiter), use harness DWG1522

    To display AC Amps on the controller, use harness DWG1518

    If you need more than 3 switched inputs and 3 switched outputs or 3 sensors, use harness DWG1477

    If wanting the enclosure order ENC0084

    For remote annunciation, use RA400-LS

     

  • Part #: TG410
  • 23 Units in Stock
  • Manufactured by: Dynagen



You might also like...

24 Volt Relay (AZ9731C24DC3E) for TG and GSC Dynagen Controllers

24 Volt Relay (AZ9731C24DC3E) for TG and GSC Dynagen Controllers
You will need 3 of these to change your TG or GSC series controllers to 24 volt operation.
$7.95

Snap-on RelayPak Option, Dynagen

Snap-on RelayPak Option, Dynagen
Snap-on RelayPak Option The RelayPak is socketed to accept four industry standard cube relays. When installed, the RelayPak (RP-100*) eliminates the need to mount and wire external slave relays for...
$48.00


ACC0027 Temp Sender, Hi Temp, 1/8"NPT for Dynagen

ACC0027 Temp Sender, Hi Temp, 1/8"NPT for Dynagen
NPTF Temp Sender. 280F, 1/8" - 27 NPTF Fits all Dynagen controllers with digital display.  
$16.49

ACC0108 Oil Sender for Dynagen GSC300, GSC400, TG350 & TG410

ACC0108 Oil Sender for Dynagen GSC300, GSC400, TG350 & TG410
This hi quality Stewart Warner sender is rated 0-100 psi.  Compatable with all Dynagen controllers that use an oil sender to display oil pressure on the digital panel.  Has i/8" NPT...
$62.68


Dynagen ACC0046, Current Transformer 200:5 Amp

Dynagen ACC0046, Current Transformer 200:5 Amp
Dynagen 200A:5A Current Transformer Can replace the following CT's: AL201 2RL201
$29.95

Governors America"GAC" ESD2244-24 Control, 24V

Governors America"GAC" ESD2244-24 Control, 24V
This is a new 24VDC governor control capable of running actuators on a constant speed engine or generator set. Compatible with Woodward and Barber Colman actuators mpounted on top of Stanadyne...
$310.00  $259.95
Save: 16% off

Dynagen ACC0045, Current Transformer 100:5 Amp

Dynagen ACC0045, Current Transformer 100:5 Amp
Current Transformer, 10KV, 100A:5A Can replace the following CT's: AL101 2RL101
$29.95


Hotstart TPS151GT8-000 Heater for Onan 333-0588-03 and Kohler

Hotstart TPS151GT8-000 Heater for Onan 333-0588-03 and Kohler
We have a low price policy! Dealer prices and quantity discounts also available. This is primarily used on gas engines.  We recommend the TPS151GT10-000 Block Heater for diesel engines....
$178.81  $119.95
Save: 33% off

Basic Harness for GSC400

Basic Harness for GSC400
5ft Harness Starter Kit (AC Current Sensing, Digital Input, and Analog Input Cables)
$47.00

Dynagen DWG1477, Advanced IO Harness

Dynagen DWG1477, Advanced IO Harness
 2 SW IN, 3 SW OUT, 1 Universal Sensor
$19.00


Dynagen GSC400 Plus Controller for Generator & KPC-1000

Dynagen GSC400 Plus Controller for Generator & KPC-1000
Please note before ordering this part:  The GSC400 has been in production for approximately 13 years, and is a great product to this day. However, because of advances in technology and newer...
$549.00  $489.00
Save: 11% off

RA400-LS, Rmt Annun RA-400 for GSC400 and TG410

RA400-LS, Rmt Annun RA-400 for GSC400 and TG410
RA400 User Manual Data Sheet Note: The enlcosure will not be included, order ACC0109
$445.50


Basler AVC63-4 Voltage Regulator, Genuine AVR

Basler AVC63-4 Voltage Regulator, Genuine AVR
New Genuine Basler AVC63-4 Voltage Regulator input power & sensing 190-240 Vac Output 63 Vdc, 4 Amps Exact equal for PowerTech PT# 06REG634AVC  Basler Voltage Regulator 63-4 AVC NOTE:...
$267.00  $214.95
Save: 19% off

3034572-A 5/8" Mag Pickup, Cummins Type

3034572-A 5/8" Mag Pickup, Cummins Type
Replacement 5/8" Mag Pickup for Cummins 3034572
$44.95

Model GSC400-PGMR Dynagen (Programmer Kit for GSC400)

Model GSC400-PGMR Dynagen (Programmer Kit for GSC400)
This is the software & cable kit to program the GSC400 series with your laptop or any compatible PC. Every setting of the feature-rich GSC400 is easily configured with its powerful, yet...
$169.95


Netbiter EC150 Remote Monitor for Generators & Equipment

Netbiter EC150 Remote Monitor for Generators & Equipment
Excellent to monitor your Generator when used with Dynagen TG350, TG410, and GSC400! The Netbiter EC150 communication gateway connects to field equipment via several connection methods: Serial...
$629.00

Rectifier / diode kit RSK-2001 for Stamford Newage / Cummins

Rectifier / diode kit RSK-2001 for Stamford Newage / Cummins
Aftermarket replacement for RSK2001. Fits Stamford Newage generators UCI22 & UCI27 includes: 3 Forward Diodes with Red Leads 3 Reverse Diodes with Black Leads NOTICE:  These diodes...
$95.00

Newage AS440, Cummins Onan A029J089 replacement regulator AVR

Newage AS440, Cummins Onan A029J089 replacement regulator AVR
This is an "exact replacement" for the following voltage regulators: Stamford Newage AS440 Stamford Newage E000-24403 or E000-24403/1P Cummins Onan A029J089 Also replaces the following...
$249.00  $199.95
Save: 20% off

3/8" UNF Magnetic Pickup / Speed Sensor for Generator

3/8" UNF Magnetic Pickup / Speed Sensor for Generator
This quality mag pick-up has 3/8" fine threads, 2.5" long. Has 6 foot shielded cable attached. *Replaces the following: Barber Colman DYNT-17200 Generac 82130D / 0 82130D Kohler...
$62.95


New AVR for Stamford SX460, E000-24600 & Onan 305-0982

New AVR for Stamford SX460, E000-24600 & Onan 305-0982
Also replaces obsolete Stamford Newage Series 6 E000-26000 and 450-13900.  This is an exact replacement Voltage Regulator for the following: Stamford Newage SX460 E000-24600 E000-24602 Cummins...
$169.00  $109.00
Save: 36% off

24 Volt Relay # RLY0017 for ES52 and ES51 Dynagen Control

24 Volt Relay # RLY0017 for ES52 and ES51 Dynagen Control
These heavy-duty 24VDC relays must be installed in the Dynagen ES51 or ES52 series engine controller for 24V DC engines or generators.  This is Dynagen Accessory # RLY0017. YOU MUST BUY TWO to...
$4.99


Copyright © 2018 Advanced Service And Parts LLC (A.S.A.P). Powered by Zen Cart | Custom Zen Cart work by ZenExpert