TE350 TOUGH Series Digital Genset Control, Dynagen

All modules in this series are easily configured as either engine controllers or as generator controllers using either the front panel buttons or our PC configurator software.

TOUGH series controllers are ideally suited for severe duty applications where reliability is critical such as mobile or stationary engine equipment and generators. 

Downloads

For a complete list of available support documents please visit the DynaGen Support Section

Dynagen SpecSheet TE350

Manual - TE350 User Manual

TE350

PRO TE is the most advanced option in the TOUGH Series®, providing full color displays of Oil Pressure, Engine Temperature, Fuel Level, Oil Level, Engine Hours, RPM and Battery Voltage as well as J1939 Diagnostic Trouble Codes and a 150 Event Log. Two customer-defined sensor parameters for temperature, pressure, voltage or levels can also be configured.  A Modbus communications port is standard, allowing connection of a remote annunciator or an Internet gateway for remote management.

ACCESSORIES FOR THE TE350:

Are you using the relay pack? If so, order DWG1475 and RP-100

If you do NOT need the relay pack, you'll need harness DWG1476

For displaying AC volts or using the generator output to sense speed, use harness DWG1479

If the engine is electronic (CANBUS/J1939 capable), or you're using a magnetic pickup for speed sensing or you're needing Modbus capabilities (such as a RA400 or Netbiter), use harness DWG1522

If you need more than 3 switched inputs and 3 switched outputs or 3 senors, use harness DWG1477

If wanting the enclosure order ENC0084 11.5x11.5x8.5" or ENC0080 8x8x4"

Optional Emergency Stop Switch - for 5A-10A, order ACC75105-2NC. For up to 20A, order ACC87941.

For 2 pole, 30A Fuse holder, order AFB01G2P.

For 3 pole, 30A Fuse holder, order AFB01F3P.

For fuses, order BBS-1.

For DIN Rail order DINRAIL-8IN.