Model GSC400-PGMR Dynagen (Programmer Kit for GSC400)

This is the software & cable kit to program the GSC400 series with your laptop or any compatible PC.

Please note:  As the GSC400 is being replaced by the TG410 due to advancements in technology, we are reducing our stock on these programmers to a minimum. If you need this product, and see there is less than 2 showing in stock, please contact us to verify availabvility.  If you place an order online, and it is not in stock, be aware that it will take longer for this programmer to ship, as we will need to order it first. OR we can drop-ship from Dynagen factory direct to you in many cases, but again - it is best to contact us prior to placing your order if you do not see stock on line!

Every setting of the feature-rich GSC400 is easily configured with its powerful, yet easy-to-use PC-based software interface.  Below are most of the functions available to you:

Sensor Inputs

• (Sender/Switch or J1939)

• High Engine Temp

• Low Oil Pressure

• Fuel Level

• Oil Level

• Fuel in Basin

• Low Engine Temp

Switched Output Functions (Select up to 9)

• Warm-up

• Energize-to-Stop

• Pre-heat

• Cool-down

• Overcrank

• High Temp Failure/Warning

• Low Oil Failure/Warning

• Underspeed Failure/Warning

• Overspeed Failure/Warning

• Low Fuel Failure/Warning

• Battery Failure/Warning

• Low Coolant Failure/Warning

• Not-in-Auto

• General Failure

• Crank Rest

• Engine Running

• Engine Cranking

• Exerciser Alarm

• Battery Recharge Alarm

• Under Voltage Warning

• Over Voltage Warning

• Over Current Warning

• Fuel-in-Basin Warning

• Voltage Regulator

• Low Temperature

• Backlight

• Auxiliary Warning

• Maintenance Timer

• System Ready

• Common Fault

• Dummy Load

• High Fuel Level

• Current Latch

• User Configurable

• Warning 1 & 2

• User Configurable

• Failure 1 & 2

Timers

• Pre-heat, Mid-heat & Post-heat

• Delay-to-Start

• Warm-up & Cool-down

• Energize-to-Stop

• Programmable Engine Exerciser

Battery Functions

• Low/High Battery

• Warning & Failure

• Autostart on Low

• Battery Function

AC Functions

• Overspeed/Underspeed Warning & Failure

• Over/Under Frequency Warning & Failure

• Over/Under Voltage

• Warning & Failure

• Over Current Warning & Failure

• AC Secondary Crank Disconnect

Switched Input Functions (Select up to 8)

• Emergency Stop

• Low Air Pressure

• Low Hydraulic Pressure

• Low Oil Pressure

• EPS Supplying Load

• Alarm Silence

• Low Coolant

• Voltage Topology Select 1 & 2

• Idle Mode

• Start/Stop

• Charger Fault 1 & 2

• High Fuel Level

• Auxiliary Failure & Warning

• User Configurable Warning 1 & 2

• User Configurable Failure 1 & 2

• Part #: GSC400-PGMR
• Manufactured by: Cattron