Please Note!  The TG410 is currently UNAVAILABLE from the factory.  This part will be on back-order until approximately the first week in October.  If you are ok with waiting, feel free to proceed to the check-out.  

Otherwise, the TE410 is a suitable replacement having the same fit, form, and function and acts identical to the TG410, IF the same firmware is installed.  The main difference is that the TE410 buttons are labeled with the rabbit / turtle symbol on them to allow variable speed control on newer electronic engines.  Click here for information on the TE410. 

Tough Series - For engines or generators

The TOUGH series controllers are designed to provide complete control, protection and engine instrumentation for both standard and electronic CAN Bus engines as well as metering for generator applications.

All modules in this series are easily configured as either engine controllers or as generator controllers using either the front panel buttons or our PC configurator software.

TOUGH series controllers are ideally suited for severe duty applications where reliability is critical such as mobile or stationary engine equipment and generators.

The TG410 is the most advanced option in the TOUGH Series, providing displays of Oil Pressure, Engine Temperature, Fuel Level, Oil Level, Engine Hours, RPM and Battery Voltage as well as J1939 Diagnostic Trouble Codes and a 150 Event Log.  Two customer-defined sensor parameters for temperature, pressure, voltage or levels can also be configured.  For generator applications, the TG410 provides a display of 3-Phase AC voltage, 3-Phase AC current, and frequency.  A Modbus communications port is standard on the TG410 model, allowing connection of a remote annunciator or an Internet gateway for remote management.  For applications requiring Auto Mains Failure operation, the TG350AMF model is recommended.

Download Tech Sheet

Download User Manual Here

Accessories for the TG410:

Are you using the relay pack? If so, order DWG1475 and RP-100

If you do NOT need the relay pack, you'll need harness DWG1476

For displaying AC volts or using the generator output to sense speed, use harness DWG1479

If the engine is electronic (CANBUS/J1939 capable), or you're using a magnetic pickup for speed sensing or you're needing Modbus capabilities (such as a RA400 or Netbiter), use harness DWG1522

To display AC Amps on the controller, use harness DWG1518

If you need more than 3 switched inputs and 3 switched outputs or 3 sensors, use harness DWG1477

If wanting the enclosure order ENC0084

For remote annunciation, use RA400-LS

For further help determing which harnesses you need, view our harness chart here.